Thinking of getting rid of this amp. Only reason Im letting it go is I have no need for a 4-channel anymore, I have a mono for the subs and dont have room for this larger tsunami,lol. Looking for maybe $100 shipped, seen them on ebay for around 120 I'd be willing to trade for a 2channel amp, preferably a small footprint one with 85-100watts x 2 with some cash perhaps. This amp has recently been repaired by Sergey at K&B Audio, had some issues with the pre-outs on my DEH8600 //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif Full 3 month warranty on it from K&B iirc. . Its bulletproof now.The logo on the front has a chip in it, like a little of the outer edge broke off, and a few scrathes, other than that its beautiful Specs are
Tsunami DB4440
High Current, 2 ohm stable Amplifier
440 WATT HIGH POWER AMPLIFIER
* 4 X 75 Watts RMS @ 4 Ohms .05% THD
* 4 x 110 WRMS @ 2 Ohms .1% THD
* 2 x 220 WRMS @ 4 Ohms Bridged .1% THD.
* High Thermal Efficiency Heat Sink Design
* Distinctive Back Lit Logo Badge
* Signal to Noise Ratio -90dB
* Input Sensitivity 240mV to 6 * 2-4 CH Input Selectors
* Variable Low Pass Filter 50-250 Hz
* Variable High Pass Filter 50-1.25 KHz
* Variable Phase Control 0-180 DEG.
* Current and Thermal Protection
* Stereo, Bridge, and Tri-Mode System Capable
Anybody got some input/offers?
Tsunami DB4440
High Current, 2 ohm stable Amplifier
440 WATT HIGH POWER AMPLIFIER
* 4 X 75 Watts RMS @ 4 Ohms .05% THD
* 4 x 110 WRMS @ 2 Ohms .1% THD
* 2 x 220 WRMS @ 4 Ohms Bridged .1% THD.
* High Thermal Efficiency Heat Sink Design
* Distinctive Back Lit Logo Badge
* Signal to Noise Ratio -90dB
* Input Sensitivity 240mV to 6 * 2-4 CH Input Selectors
* Variable Low Pass Filter 50-250 Hz
* Variable High Pass Filter 50-1.25 KHz
* Variable Phase Control 0-180 DEG.
* Current and Thermal Protection
* Stereo, Bridge, and Tri-Mode System Capable
Anybody got some input/offers?
