Reply to thread

Message: <blockquote data-quote="Basshead21" data-source="post: 7099848" data-attributes="member: 626085">I am a complete noob at ohms, and ohm loads. I just drilled a 3 inch hole for a 4 1/8 in terminal cup. So the HDC3 15 I have has two different sets of wires, positives and negatives. and my amp (AQ1200) has two positive and two negative ports. So basically my question is should I put the two positives on one end of the terminal cup, and put the two negatives on the other end of the terminal cup? Or will I have to buy another terminal cup and put one single positive to one end of the terminal cup and one single negative to the other side of the terminal cup, and then do the same with another terminal cup? Sorry for the retarded question, I attempted to word it the best I could.-Basshead</blockquote>

Top