Reply to thread

Message: <blockquote data-quote="devin171moto" data-source="post: 8705198" data-attributes="member: 679009">did you replace the radio for rca outs or use line output? or god forbid just shoved speaker wire into the rca input I saw an installation tutorial on the mtx subs where they did that and I was horrified. post pics of the installation if possible. check that your grounded in a good place and it's tight onto body. make sure your low pass filter is around 80hz. and your subsonic is no higher than 25hz. no bass boost. try setting the gain till mono output is at 24v.verify final impedance of the box is 2 ohms with a multi-meter.if you're using a stock radio. It could be killing your sub frequencies.Other than that. you might be expecting too much from those.</blockquote>

Top