Reply to thread

Message

<blockquote data-quote="bugflipper" data-source="post: 6843133" data-attributes="member: 621756">10&quot;Dual 3.1ohmsFs-26HzQts-0.47Vas-2.1Ft^2SPL-84dbQes-0.51Qms-5.0Sd-345cm^2Power handling - 1000rmsCONEMachines titanium cone spun from solid titanium alloy. Ultra-light, ultra-tough.SURROUNDMade from a special durometer Poly-ether foam. High excursionVOICE COILLarge 3&quot; aluminum former, thermally bonded to the come as a heat-sink for the voice coil. The voice coil wire itself is wound to a 2.3&quot; winding length, as a 4-layer voice coil.MAGNETS!!Attached to the frame are premium quality triple stacked 75oz magnetsDo treat like a dual 4 ohm. They were also sw9102 with same basic design. In the sw line they rated them at dual 4, but they were still dual 3.1. I am running two in the front of a Porsche Speedster. My feet get numb after a while and they are only seeing around 500 watts. These are the only subs I found that will get close to a w7 for sql. W7 enclosure recommendations match up well. Just remember JL recommends too small of a box so always go bigger if you have the room. Sealed 1.5 or ported 2.0 is a good start. If not you will not get as good of low bass response. JL designs their enclosures for maximum spl. Yet they try to base their product line on sq. Go figure?</blockquote>

[QUOTE="bugflipper, post: 6843133, member: 621756"] 10" Dual 3.1ohms Fs-26Hz Qts-0.47 Vas-2.1Ft^2 SPL-84db Qes-0.51 Qms-5.0 Sd-345cm^2 Power handling - 1000rms CONE Machines titanium cone spun from solid titanium alloy. Ultra-light, ultra-tough. SURROUND Made from a special durometer Poly-ether foam. High excursion VOICE COIL Large 3" aluminum former, thermally bonded to the come as a heat-sink for the voice coil. The voice coil wire itself is wound to a 2.3" winding length, as a 4-layer voice coil. MAGNETS!! Attached to the frame are premium quality triple stacked 75oz magnets Do treat like a dual 4 ohm. They were also sw9102 with same basic design. In the sw line they rated them at dual 4, but they were still dual 3.1. I am running two in the front of a Porsche Speedster. My feet get numb after a while and they are only seeing around 500 watts. These are the only subs I found that will get close to a w7 for sql. W7 enclosure recommendations match up well. Just remember JL recommends too small of a box so always go bigger if you have the room. Sealed 1.5 or ported 2.0 is a good start. If not you will not get as good of low bass response. JL designs their enclosures for maximum spl. Yet they try to base their product line on sq. Go figure? [/QUOTE]

Verification