Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Eclipse 88150 aluminum enclosure help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="UMWDawg92" data-source="post: 7624020" data-attributes="member: 624119"><p>So I'll be getting an eclipse 88150DVC aluminum in a couple days and I've been working on designing the enclosure for it. The t/s specs have been hard to find but this is what I've found:</p><p></p><p>Qts .39</p><p></p><p>Qms 5.00</p><p></p><p>Qes .423</p><p></p><p>Vas 6.1 cu feet</p><p></p><p>Fs 27hz</p><p></p><p>Re 3.0</p><p></p><p>I've noticed eclipse does not recommend porting this sub but when I run it in WinISD it models very nice and flat in a low tuned ported box, I'm getting that 4.5-5 cubes net tuned to 27-28hz looks really good. I'm going for SQ over output. So what do you guys think? Does that seem about right? Oh and what kind of port area should I use?</p></blockquote><p></p>
[QUOTE="UMWDawg92, post: 7624020, member: 624119"] So I'll be getting an eclipse 88150DVC aluminum in a couple days and I've been working on designing the enclosure for it. The t/s specs have been hard to find but this is what I've found: Qts .39 Qms 5.00 Qes .423 Vas 6.1 cu feet Fs 27hz Re 3.0 I've noticed eclipse does not recommend porting this sub but when I run it in WinISD it models very nice and flat in a low tuned ported box, I'm getting that 4.5-5 cubes net tuned to 27-28hz looks really good. I'm going for SQ over output. So what do you guys think? Does that seem about right? Oh and what kind of port area should I use? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Eclipse 88150 aluminum enclosure help
Top
Menu
Home
Refresh