Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Head Units
Eclipse 7200mkII tuning/setup
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Rubrignitz" data-source="post: 6536924" data-attributes="member: 609308"><p>My gains were about 50-60% on the sub and front channel. I cranked both of them all the way down...didn't have much time to test it last night but **** these are some STRONG outputs!! The sub needs a bit more level but the front stage is super with the gain all the way down lol.</p><p></p><p>I'll adjust the EQ best I can by ear and pick up the MEI100 microphone next week, see how that auto-tune works out. I wasn't happy with the e-iserv one at all.</p><p></p><p>Amp specs:</p><p></p><p>MODEL POWER 1000</p><p></p><p>Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts</p><p></p><p>Front and Rear Channels</p><p></p><p>4 Load Per Channel 50 Watts x 4</p><p></p><p>2 Load Per Channel 100 Watts x 4</p><p></p><p>1 Load Per Channel 150 Watts x 4</p><p></p><p>4 Load Bridged 200 Watts x 2</p><p></p><p>2 Load Bridged 300 Watts x 2</p><p></p><p>Sub Channel</p><p></p><p>4 Load Per Channel 300 Watts x 1</p><p></p><p>2 Load Per Channel 600 Watts x 1</p><p></p><p>1 Load Per Channel 800 Watts x 1</p><p></p><p>Dimensions: Height 2.6" (6.60cm)</p><p></p><p>Width 12.8" (32.51cm)</p><p></p><p>Length 23" (58.42cm)</p><p></p><p>Amplifier Fuse Rating (Amp/Type) (1) 250A / ANL</p><p></p><p>Battery Fuse Rating (Amp) External (Not Supplied) 250A</p><p></p><p>Signal-to-Noise Ratio &gt;80dB A-weighted @ 2Vrms</p><p></p><p>Crossover Slope (Front and Rear Channels) Selectable 12dB/octave Butterworth or</p><p></p><p>24dB/octave Linkwitz-Riley</p><p></p><p>Crossover Slope (Sub Channel) 12dB/octave Butterworth</p><p></p><p>Crossover Frequency (Front and Rear) (Multiplier x1) variable from 40Hz to 400Hz</p><p></p><p>Crossover Frequency (Front and Rear) (Multiplier x10) variable from 400Hz to 4000Hz</p><p></p><p>Crossover Frequency (Sub Channel) (Low Pass Only) variable from 32Hz to 250Hz</p><p></p><p>Frequency Response (Front and Rear) 20Hz to 20kHz ±0.5dB</p><p></p><p>Frequency Response (Sub Channel) 20Hz to 250Hz -3dB</p><p></p><p>Bandwidth 20Hz to 200kHz ±3dB</p><p></p><p>Slew Rate 30 Volts/μS</p><p></p><p>IM Distortion (IHF)</p><p></p><p>Signal Voltage Adjustment Range Variable from 150mV to 4V (RCA Input)</p><p></p><p>Protection NOMAD - Internal analog-computer output protection circuitry</p><p></p><p>limits power in case of overload, plus short protection.</p><p></p><p>Thermal switch shuts down the amplifier in case of overheating.</p><p></p><p>Equalization (Variable Punch Bass) Variable from 0dB to +18dB @ variable 35 to 70Hz</p><p></p><p>Input Impedance 10k ohms</p><p></p><p>Infrasonic Filter (Sub Channel) Selectable 12dB/Octave, -3dB @ 28Hz</p></blockquote><p></p>
[QUOTE="Rubrignitz, post: 6536924, member: 609308"] My gains were about 50-60% on the sub and front channel. I cranked both of them all the way down...didn't have much time to test it last night but **** these are some STRONG outputs!! The sub needs a bit more level but the front stage is super with the gain all the way down lol. I'll adjust the EQ best I can by ear and pick up the MEI100 microphone next week, see how that auto-tune works out. I wasn't happy with the e-iserv one at all. Amp specs: MODEL POWER 1000 Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts Front and Rear Channels 4 Load Per Channel 50 Watts x 4 2 Load Per Channel 100 Watts x 4 1 Load Per Channel 150 Watts x 4 4 Load Bridged 200 Watts x 2 2 Load Bridged 300 Watts x 2 Sub Channel 4 Load Per Channel 300 Watts x 1 2 Load Per Channel 600 Watts x 1 1 Load Per Channel 800 Watts x 1 Dimensions: Height 2.6" (6.60cm) Width 12.8" (32.51cm) Length 23" (58.42cm) Amplifier Fuse Rating (Amp/Type) (1) 250A / ANL Battery Fuse Rating (Amp) External (Not Supplied) 250A Signal-to-Noise Ratio >80dB A-weighted @ 2Vrms Crossover Slope (Front and Rear Channels) Selectable 12dB/octave Butterworth or 24dB/octave Linkwitz-Riley Crossover Slope (Sub Channel) 12dB/octave Butterworth Crossover Frequency (Front and Rear) (Multiplier x1) variable from 40Hz to 400Hz Crossover Frequency (Front and Rear) (Multiplier x10) variable from 400Hz to 4000Hz Crossover Frequency (Sub Channel) (Low Pass Only) variable from 32Hz to 250Hz Frequency Response (Front and Rear) 20Hz to 20kHz ±0.5dB Frequency Response (Sub Channel) 20Hz to 250Hz -3dB Bandwidth 20Hz to 200kHz ±3dB Slew Rate 30 Volts/μS IM Distortion (IHF) Signal Voltage Adjustment Range Variable from 150mV to 4V (RCA Input) Protection NOMAD - Internal analog-computer output protection circuitry limits power in case of overload, plus short protection. Thermal switch shuts down the amplifier in case of overheating. Equalization (Variable Punch Bass) Variable from 0dB to +18dB @ variable 35 to 70Hz Input Impedance 10k ohms Infrasonic Filter (Sub Channel) Selectable 12dB/Octave, -3dB @ 28Hz [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Head Units
Eclipse 7200mkII tuning/setup
Top
Menu
What's new
Forum list
