Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Easy Wiring Question!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="CrossoverOre" data-source="post: 8171753" data-attributes="member: 642052"><p>I would use the crossovers for the tweets as they are tuned at the factory. Without knowing what kind of head unit I would just run all the front door amps from the front channel off the deck. Hell even if we did know I would probably still do it that way anyway. One set of rca's from the head to either amp and use the output rca's from one amp to the other to pass the signal through. from there the 4ch amp has a 2ch 4ch input switch, just select 2ch input. 12 ga should suffice for signal from amp to speakers. Other than that sounds like you are on track. with that many speakers going into the doors I would make sure your build out is ****** tough. BTW deaden the hell out of your doors.</p></blockquote><p></p>
[QUOTE="CrossoverOre, post: 8171753, member: 642052"] I would use the crossovers for the tweets as they are tuned at the factory. Without knowing what kind of head unit I would just run all the front door amps from the front channel off the deck. Hell even if we did know I would probably still do it that way anyway. One set of rca's from the head to either amp and use the output rca's from one amp to the other to pass the signal through. from there the 4ch amp has a 2ch 4ch input switch, just select 2ch input. 12 ga should suffice for signal from amp to speakers. Other than that sounds like you are on track. with that many speakers going into the doors I would make sure your build out is ****** tough. BTW deaden the hell out of your doors. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Easy Wiring Question!!
Top
Menu
Home
Refresh