Reply to thread

Message: <blockquote data-quote="jonesfromindia" data-source="post: 2273213" data-attributes="member: 571441">you need a distro block in order to send the signal of the pos to 2 dif amps. not very hard. if you are amping them which i believe you said you have to know the impedance the amp can do. your speakers are 4 ohms, your amp should be fine, but double check it can do 4 ohms. then once you get your speakers if there is a certain way to wire it to 4 ohms which should just be POS to POS on amp and NEG to NEG on amp, but your amp must be 4 ohms too.that should be it.</blockquote>

Top