Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Dynamat install tips? newbie...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="E368" data-source="post: 2563711" data-attributes="member: 568601"><p>I have a bunch of Dynamat Extreme and Tacmat that I want to use to reduce road noise in my car but I am looking for tips on where and how to apply it.</p><p></p><p>So far I did the driver's door...I applied the Dynamat over all the large voids/holes in the sheet metal and then put the door panel back on. Is this the correct way to do it? I have no idea where the Tacmat goes of if I should even bother with it?</p><p></p><p>What exactly is the installation goal with these products? Any advice would be appreciated.</p></blockquote><p></p>
[QUOTE="E368, post: 2563711, member: 568601"] I have a bunch of Dynamat Extreme and Tacmat that I want to use to reduce road noise in my car but I am looking for tips on where and how to apply it. So far I did the driver's door...I applied the Dynamat over all the large voids/holes in the sheet metal and then put the door panel back on. Is this the correct way to do it? I have no idea where the Tacmat goes of if I should even bother with it? What exactly is the installation goal with these products? Any advice would be appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Dynamat install tips? newbie...
Top
Menu
What's new
Forum list
