Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
dual tapped horn
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="akheathen" data-source="post: 7476132" data-attributes="member: 629234"><p>can somone help me out with some figures on how to tune one? here is what i need- i have hornresp, but don't fully understand how to use it. have a pair of <a href="http://www.sonicelectronix.com/item_377_Infinity-Kappa-52.5i-5-1-4.html" target="_blank">Infinity 52.5I (525i) 5-1/4" Speakers - Sonic Electronix</a> and have the basic design in mind, but would like to know where to start roughly on the lenght and widths/taper. i plan on recessing the motors through the back-side to get the desired width at the drivers. also, it will start as 3 horns at the back of the drivers, and converge into one opening. thank you</p></blockquote><p></p>
[QUOTE="akheathen, post: 7476132, member: 629234"] can somone help me out with some figures on how to tune one? here is what i need- i have hornresp, but don't fully understand how to use it. have a pair of [URL="http://www.sonicelectronix.com/item_377_Infinity-Kappa-52.5i-5-1-4.html"]Infinity 52.5I (525i) 5-1/4" Speakers - Sonic Electronix[/URL] and have the basic design in mind, but would like to know where to start roughly on the lenght and widths/taper. i plan on recessing the motors through the back-side to get the desired width at the drivers. also, it will start as 3 horns at the back of the drivers, and converge into one opening. thank you [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
dual tapped horn
Top
Menu
Home
Refresh