Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
DLS MS6 Crossover Settings
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ecbmxer" data-source="post: 1290199" data-attributes="member: 562674"><p>What settings are supposed to be inside my MS6 component crossover? On the case it just says "selectable tweeter level inside" and the same thing in the instructions. But then in the diagram in the instruction manual it shows another place for a jumper and a hi/low setting (crossover freq?). In my crossover I have four holes in this location but no jumper. I have a jumper for the tweeter level. Is this right or am I supposed to have a jumper for the crossover frequency also? Oh and what settings would everybody reccomend for installing the woofer in the door and the tweeter in the dash?</p><p></p><p>Thanks!</p></blockquote><p></p>
[QUOTE="ecbmxer, post: 1290199, member: 562674"] What settings are supposed to be inside my MS6 component crossover? On the case it just says "selectable tweeter level inside" and the same thing in the instructions. But then in the diagram in the instruction manual it shows another place for a jumper and a hi/low setting (crossover freq?). In my crossover I have four holes in this location but no jumper. I have a jumper for the tweeter level. Is this right or am I supposed to have a jumper for the crossover frequency also? Oh and what settings would everybody reccomend for installing the woofer in the door and the tweeter in the dash? Thanks! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
DLS MS6 Crossover Settings
Top
Menu
What's new
Forum list
