Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Distribution blocks
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="von" data-source="post: 6110746" data-attributes="member: 611938"><p>Hey guy's or gal's, I am using a tsunami dual amp wiring kit, to hook up my new system, according to th specs it comes with an agu distribution block,a positive- negative distribution block, and a ground distribution block, my setup is as follows.a priemer deh-600ub head unit, alpins pdx 5 5 channel amp,alpines pdx-4.150 planning on bridging to 300x 2 using 2 12 inch xsite subs until I buy of alpines 10 inch type r subs,as for the front I have alpines spr-17s components, and alpines spr-69c at the rear panels.will I need all three distribution blocks or is it just alot of clutter?also using the 5th channel on the pdx5 for one sub the 2nd amp for other 2 subs school me on if I should bridge the pdx-4.150 which would be 300x2 for the two remaining subs or should i go with a 600 watt mono for the other subs? this is my first system.</p></blockquote><p></p>
[QUOTE="von, post: 6110746, member: 611938"] Hey guy's or gal's, I am using a tsunami dual amp wiring kit, to hook up my new system, according to th specs it comes with an agu distribution block,a positive- negative distribution block, and a ground distribution block, my setup is as follows.a priemer deh-600ub head unit, alpins pdx 5 5 channel amp,alpines pdx-4.150 planning on bridging to 300x 2 using 2 12 inch xsite subs until I buy of alpines 10 inch type r subs,as for the front I have alpines spr-17s components, and alpines spr-69c at the rear panels.will I need all three distribution blocks or is it just alot of clutter?also using the 5th channel on the pdx5 for one sub the 2nd amp for other 2 subs school me on if I should bridge the pdx-4.150 which would be 300x2 for the two remaining subs or should i go with a 600 watt mono for the other subs? this is my first system. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Distribution blocks
Top
Menu
Home
Refresh