Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Subwoofers
Diamond Audio Hex 6 1/2" components
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Unregistered" data-source="post: 11065"><p>I really have two questions. The first is would 80wrms be enough to really make the Hex s600s sound good, or should I put more power to them?</p><p></p><p>The second is this: I have an 80x4 watt PPI amp, and if I run two sets of speakers in parallel to two channels (for 2 ohms stereo 160x2wrms) then each set of speakers will see roughly half (depending on the actual resistance of each speaker) of the power, correct?</p><p></p><p>My planned setup is to bridge the rear channels of the PPI (320wrms) to a Perfect 10" sub, and run the front channels in parallel to a set of Diamond Hexs in the front and some other set (still undecided) in the back. Any comments on this would be appreciated</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="Unregistered, post: 11065"] I really have two questions. The first is would 80wrms be enough to really make the Hex s600s sound good, or should I put more power to them? The second is this: I have an 80x4 watt PPI amp, and if I run two sets of speakers in parallel to two channels (for 2 ohms stereo 160x2wrms) then each set of speakers will see roughly half (depending on the actual resistance of each speaker) of the power, correct? My planned setup is to bridge the rear channels of the PPI (320wrms) to a Perfect 10" sub, and run the front channels in parallel to a set of Diamond Hexs in the front and some other set (still undecided) in the back. Any comments on this would be appreciated Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Subwoofers
Diamond Audio Hex 6 1/2" components
Top
Menu
Home
Refresh