Reply to thread

Message

<blockquote data-quote="Justintoxicated" data-source="post: 2726522" data-attributes="member: 561240">Well I only have the pre-fab ported probox, making a box for my truckis a bit to difficult fo rme since I have no table saw or anyplace to put one (I RENT).Here is the Ported box I have from them.&nbsp; <a href="http://www.proboxloaded.com/products/enclosures/loaded/nissan/NKC110L/index.shtml" target="_blank">http://www.proboxloaded.com/products/enclosures/loaded/nissan/NKC110L/index.shtml</a>Every cut would have to be at a percise angle.&nbsp; Back of the box angled, top of the box angled, maybe fiberglass to go over the hump in the middle of the seat etc.So these would be going in a sealed box.I have a Prototype sealed, downfire box from them.&nbsp; I modified it to lift it higher off the gound about 1.5 inches clearance and fit a bit better.&nbsp; I basicaly just added some feet to the box to lift it up and cut the back to slide back farther...I could try them in the pre-fab ported (it actualy fits well in my truck but It was tuned for 40 htz with the sub it came with) No idea what it would be tuned for with the diamond in there.&nbsp; If I wanted loud the $70 Assassin works well enough in this enclosure.&nbsp; I&#039;m hoping to get the same level of output as the Assassin, from 2 D6&#039;s sealed and have superior SQ.&nbsp; I&#039;ll&nbsp; be more than happy with that.&nbsp; I&#039;m not building an SPL system, but the single assassin in a sealed box is not loud enough.so in this application will D6&#039;s have better SQ and get louder than Assassins?&nbsp; Will they be as loud as arsenals?</blockquote>

[QUOTE="Justintoxicated, post: 2726522, member: 561240"] Well I only have the pre-fab ported probox, making a box for my truckis a bit to difficult fo rme since I have no table saw or anyplace to put one (I RENT). Here is the Ported box I have from them. [URL="http://www.proboxloaded.com/products/enclosures/loaded/nissan/NKC110L/index.shtml"]http://www.proboxloaded.com/products/enclosures/loaded/nissan/NKC110L/index.shtml[/URL] Every cut would have to be at a percise angle. Back of the box angled, top of the box angled, maybe fiberglass to go over the hump in the middle of the seat etc. So these would be going in a sealed box. I have a Prototype sealed, downfire box from them. I modified it to lift it higher off the gound about 1.5 inches clearance and fit a bit better. I basicaly just added some feet to the box to lift it up and cut the back to slide back farther. ..I could try them in the pre-fab ported (it actualy fits well in my truck but It was tuned for 40 htz with the sub it came with) No idea what it would be tuned for with the diamond in there. If I wanted loud the $70 Assassin works well enough in this enclosure. I'm hoping to get the same level of output as the Assassin, from 2 D6's sealed and have superior SQ. I'll be more than happy with that. I'm not building an SPL system, but the single assassin in a sealed box is not loud enough. [B]so in this application will D6's have better SQ and get louder than Assassins? Will they be as loud as arsenals?[/B] [/QUOTE]

Verification