Reply to thread

Message

<blockquote data-quote="k_schutte" data-source="post: 6732604" data-attributes="member: 551817">Kinda urgent...I have searched and read through probably 15-20 pages on these things and it seems to be almost a dead even split.&nbsp; This would be in an almost daily driver and I would set the gains to around 2500 and it will be run at 1ohm via a Fully Loaded 18&quot; BTL (D2).&nbsp; I will be turning up the gains for comps but I only do 2-3 a year.&nbsp; Now I hear they get warm and my thoughts on that are as fallows.&nbsp;&nbsp; I love the guts anyways so I want to make a plexi back plate for it and mount it so you can see the guts.&nbsp; I have a pretty dang powerful 12v fan I will mount on it as well as put some vents in the plexi.Electrical:300a Ohio Generator AlternatorBig3 done is 2/0single run of 1/0 (actually the same amount of copper as 2/0 but it was sold as 1/0 so...)2) C&amp;amp;D UPS12-350MR&#039;s (93ah or so...)as for the plexi/fan...&nbsp; should I blow air in or **** air out?&nbsp; and should I have the fan on one far side and vents on the other or fan in the middle and vents on both sides?</blockquote>

[QUOTE="k_schutte, post: 6732604, member: 551817"] Kinda urgent... I have searched and read through probably 15-20 pages on these things and it seems to be almost a dead even split. This would be in an almost daily driver and I would set the gains to around 2500 and it will be run at 1ohm via a Fully Loaded 18" BTL (D2). I will be turning up the gains for comps but I only do 2-3 a year. Now I hear they get warm and my thoughts on that are as fallows. I love the guts anyways so I want to make a plexi back plate for it and mount it so you can see the guts. I have a pretty dang powerful 12v fan I will mount on it as well as put some vents in the plexi. Electrical: 300a Ohio Generator Alternator Big3 done is 2/0 single run of 1/0 (actually the same amount of copper as 2/0 but it was sold as 1/0 so...) 2) C&D UPS12-350MR's (93ah or so...) as for the plexi/fan... should I blow air in or **** air out? and should I have the fan on one far side and vents on the other or fan in the middle and vents on both sides? [/QUOTE]

Verification