Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
Dayton Audio Box Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ciaonzo" data-source="post: 8654217" data-attributes="member: 607015"><p>Yep, sounds right.</p><p></p><p>You might try and set output at Fb (tuning frequency) because it's usually the lowest impedance the amplifier will see, since 50Hz will be in the area where the impedance peaks are higher on either side of Fb. I'm sure that the actual impedance at Fb will also be higher than 1 ohm so you will need to factor that in when you work the formula. Does PK have the impedance plot for that enclosure workup? Maybe he can quote the actual impedance at Fb for you.</p></blockquote><p></p>
[QUOTE="ciaonzo, post: 8654217, member: 607015"] Yep, sounds right. You might try and set output at Fb (tuning frequency) because it's usually the lowest impedance the amplifier will see, since 50Hz will be in the area where the impedance peaks are higher on either side of Fb. I'm sure that the actual impedance at Fb will also be higher than 1 ohm so you will need to factor that in when you work the formula. Does PK have the impedance plot for that enclosure workup? Maybe he can quote the actual impedance at Fb for you. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
Dayton Audio Box Build
Top
Menu
Home
Refresh