Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
Dayton Audio Box Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Wiz Khalifla_85" data-source="post: 8654197" data-attributes="member: 656489"><p>Update:</p><p></p><p>I’ve noticed the m1d amp getting super hot. Hot to where I can only keep my hand there for a few seconds..</p><p></p><p>Currently the gains set for about 750watts @ 1ohm and these Dayton’s need 1200</p><p></p><p>All the bass boosts n loudness @ 0.</p><p></p><p>My voltage meter is tapped into my ignition wire and it never drops below 13.8v</p><p></p><p>The Dayton’s are also getting hot to the touch after a song or two..</p><p></p><p>Maybe bc the cones are aluminum??</p><p></p><p>Is this amp gone bad? My last amp was a Onyx1.1000D and it barely got warm.. Never had any issues..</p></blockquote><p></p>
[QUOTE="Wiz Khalifla_85, post: 8654197, member: 656489"] Update: I’ve noticed the m1d amp getting super hot. Hot to where I can only keep my hand there for a few seconds.. Currently the gains set for about 750watts @ 1ohm and these Dayton’s need 1200 All the bass boosts n loudness @ 0. My voltage meter is tapped into my ignition wire and it never drops below 13.8v The Dayton’s are also getting hot to the touch after a song or two.. Maybe bc the cones are aluminum?? Is this amp gone bad? My last amp was a Onyx1.1000D and it barely got warm.. Never had any issues.. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
Dayton Audio Box Build
Top
Menu
Home
Refresh