Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Miscellaneous Automotive
Car Electronics & Appearance
Daytime running lights
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Wingman0121" data-source="post: 7313970" data-attributes="member: 620554"><p>Or you could remove the DRL relay if it's not tucked within a computer. My car has separate bulbs for DRL but my car is older. You should leave it alone if you have factory HIDs though.</p><p></p><p>Your headlight has 5 wires(3 for headlight and 2 for turn signal) so the headlight is a dual-filament bulb. I think one filament is for high-beam and the other is for DRL/low beam so cutting wires is not going to kill the DRLs unless the filament is separate for the DRL.</p></blockquote><p></p>
[QUOTE="Wingman0121, post: 7313970, member: 620554"] Or you could remove the DRL relay if it's not tucked within a computer. My car has separate bulbs for DRL but my car is older. You should leave it alone if you have factory HIDs though. Your headlight has 5 wires(3 for headlight and 2 for turn signal) so the headlight is a dual-filament bulb. I think one filament is for high-beam and the other is for DRL/low beam so cutting wires is not going to kill the DRLs unless the filament is separate for the DRL. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Miscellaneous Automotive
Car Electronics & Appearance
Daytime running lights
Top
Menu
Home
Refresh