Crunk Flammable Jello Times

I was considering trying to run these coaxials active...(yeah...funny)

http://www.dls.se/en/car/prod.html?produkt=en_93

If you look at them, there are two positive inputs and one negative.

So...I have some three-conductor wire...Could I run a jumper from the negative of one channel to the negative to another channel and then run that to the coaxials....or would it be better to run the wires and then join the two connectors at the speaker.

Or not try to run them active?

 
I was considering trying to run these coaxials active...(yeah...funny)
http://www.dls.se/en/car/prod.html?produkt=en_93

If you look at them, there are two positive inputs and one negative.

So...I have some three-conductor wire...Could I run a jumper from the negative of one channel to the negative to another channel and then run that to the coaxials....or would it be better to run the wires and then join the two connectors at the speaker.

Or not try to run them active?
It wouldn't be active if they share a common negative...

nG

 
1159587965947.jpg


nG

 
I guess I can still t/a them though....use network mode on my prs880. Not sure how much good it will do, but since I already have it...why not?

I am going to run the DLS Ca51. It says minimum is 4ga...I guess I'll either buy a new kit or run this 0/1....but I'd rather use the 4ga as it's easier to hide.

 
Activity
No one is currently typing a reply...

About this thread

UndercoverPunk

5,000+ posts
DOT
Thread starter
UndercoverPunk
Joined
Location
Dayton, OH™
Start date
Participants
Who Replied
Replies
55,255
Views
918,300
Last reply date
Last reply from
mahc
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top