Reply to thread

Message: <blockquote data-quote="keep_hope_alive" data-source="post: 7790375" data-attributes="member: 576029">^correct.  the passive crossover points are based on the load impedance.  change the impedance you change crossover frequency.  for example: if you halve the impedance load, you double the crossover point.  this is actually safe with component speakers since higher crossover points are ok (though it could sound worse).you don't want to bridge the amp anyway because you'll lose left/right information.  you want left/right up front.run the amp in stereo mode, wire left and right independently, use both crossovers, and you're good to go.</blockquote>

Top