Reply to thread

Message: <blockquote data-quote="Louisiana_CRX" data-source="post: 7492726" data-attributes="member: 570083"><p>if the usb jack  is on a harness that goes to the circuit board...you  can take the deck apart pop the usb connecter loose then attach your cable inside the deck...route it out the rear then do what you want...then just keep the usb cover closed at all times on front of the deck.....since there would be a hole there...you could gorilla tape from the inside of the deck a small piece in reverse (black side of tape ) covering the hole so it will be solid if opened</p></blockquote><p></p>

Top