Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Cant seem to get the figures i want/need when setting up.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Hrp81134" data-source="post: 8680544" data-attributes="member: 677656"><p>In addition to above I have now purchased and installed a kenwood headunit which I can get 1.6v unclipped rca voltage to the amplifier. Although this did not allow me to get more voltage out the amplifier it have allowed for better quality listening. Also I re wired the subwoofer from 4ohn down to 1ohm and have managed to get 327Watts to the subwoofer at 1ohm. Sounds ALOT better but it's still not even half way of what the sub is happy to sit at. Still very confused as at 1ohm the IPA2001D amplifier should reach 2000watt RMS. Well within the recommended RCA input to the amplifier now and I'm still holding good input volts at 13.9A on 35hz burp. Any help much appreciated</p></blockquote><p></p>
[QUOTE="Hrp81134, post: 8680544, member: 677656"] In addition to above I have now purchased and installed a kenwood headunit which I can get 1.6v unclipped rca voltage to the amplifier. Although this did not allow me to get more voltage out the amplifier it have allowed for better quality listening. Also I re wired the subwoofer from 4ohn down to 1ohm and have managed to get 327Watts to the subwoofer at 1ohm. Sounds ALOT better but it's still not even half way of what the sub is happy to sit at. Still very confused as at 1ohm the IPA2001D amplifier should reach 2000watt RMS. Well within the recommended RCA input to the amplifier now and I'm still holding good input volts at 13.9A on 35hz burp. Any help much appreciated [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Cant seem to get the figures i want/need when setting up.
Top
Menu
Home
Refresh