Can i use 4AWG for power for a P600.1bd and P250.2?

[beyap 10+ year member]

The p250.2 are hooked to 45x2WRMS @ 4ohms only while the P600.1bd is hooked up to an RE SR10D4.

This might be the wrong thread but am i overpowering the sub (rated @ 300WRMS) with my current amp?

I also, got 4awg big 3 setup.

Click to read more...

 

[blazinb2000 10+ year member]

Yes you can run 4awg with that setup, and yes you are overpowering the sub just be careful and set it up properly and you should have no problems.

 

[blazeplacid 10+ year member]

get a distrobution block

 

[blazinb2000 10+ year member]

get a distrobution block

x2 you will need a distribution block to split the wire to go to each amp, I would recommend getting a fused distro block.

 

[beyap 10+ year member]

Yes you can run 4awg with that setup, and yes you are overpowering the sub just be careful and set it up properly and you should have no problems.

when you say set it up properly, you mean minimum gain right? What else do i have to watch out for?

get a distrobution block

Done. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

One more question which everyone here seems to have a mixed opinion on... do i need a cap?