Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Builds
Car Audio Build Logs
Camry kicks and tweeter waveguide
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jeffdachef" data-source="post: 8555661" data-attributes="member: 650438"><p>never use MDF for anything ever again. Sanded 13 layer pine ply baffle and skeleton outline then coated with paint or some water proofing solution then wrap with fleece fiberglass resin and add layers of mat then more fiberglass then bondo then sand.</p><p></p><p>requires cutting door panels and making a whole enclosure for the 10. If you try to use the whole door alone, you'll run into a lot of nasty unsolvable rattles that deadener will not prevent depending how much power you throw on the 10s.</p></blockquote><p></p>
[QUOTE="Jeffdachef, post: 8555661, member: 650438"] never use MDF for anything ever again. Sanded 13 layer pine ply baffle and skeleton outline then coated with paint or some water proofing solution then wrap with fleece fiberglass resin and add layers of mat then more fiberglass then bondo then sand. requires cutting door panels and making a whole enclosure for the 10. If you try to use the whole door alone, you'll run into a lot of nasty unsolvable rattles that deadener will not prevent depending how much power you throw on the 10s. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Builds
Car Audio Build Logs
Camry kicks and tweeter waveguide
Top
Menu
What's new
Forum list
