Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
CALLING ALL (((***** Am Owners)))
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="1BadHawk" data-source="post: 89694" data-attributes="member: 545326"><p>Your right the 4th gen engine bay leaves no room for anything. Its difficult enough just to see the firewall let alone get to it.</p><p></p><p>I was condiering something like what Frraksurred mentioned. Running the power wire along the underside of the car. Then make entry into the rear compartment. Im a bit concerned though with both the weather and debrit factor. I'd sure hate to rub a speed hump, or have something bounce up under neath and cut the wires insulation or worse. Im just not sure yet. Though it would eliminate any trip hazards or eye sores that running it through the passenger compartment might cause.</p></blockquote><p></p>
[QUOTE="1BadHawk, post: 89694, member: 545326"] Your right the 4th gen engine bay leaves no room for anything. Its difficult enough just to see the firewall let alone get to it. I was condiering something like what Frraksurred mentioned. Running the power wire along the underside of the car. Then make entry into the rear compartment. Im a bit concerned though with both the weather and debrit factor. I'd sure hate to rub a speed hump, or have something bounce up under neath and cut the wires insulation or worse. Im just not sure yet. Though it would eliminate any trip hazards or eye sores that running it through the passenger compartment might cause. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
CALLING ALL (((***** Am Owners)))
Top
Menu
What's new
Forum list