Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Building dual ported box for two 12 inch Type R's - What tools do I need?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="plantinseeds" data-source="post: 7694797" data-attributes="member: 638917"><p>I will most likely do the cuts myself unless Home Depot/Menards/Lowes does the cuts for free (Doubt they do), but should I be good with just liquid nails and hammer and nails? Are there any disadvantages from using nails instead of screws besides having the ability to disassemble it easier?</p><p></p><p>How would I connect the speaker wire to the bolt on the inside of the enclosure? Wrap it around the bolt and solder or use ring crimps?</p><p></p><p>EDIT: Also random question, but if you know anything about Optima Batteries, do you know if there is a big difference between the group D34 and the D35? I was forced to pay 20$ extra today because the D34 wouldn't fit under my hood because my stock battery had reverse posts.</p></blockquote><p></p>
[QUOTE="plantinseeds, post: 7694797, member: 638917"] I will most likely do the cuts myself unless Home Depot/Menards/Lowes does the cuts for free (Doubt they do), but should I be good with just liquid nails and hammer and nails? Are there any disadvantages from using nails instead of screws besides having the ability to disassemble it easier? How would I connect the speaker wire to the bolt on the inside of the enclosure? Wrap it around the bolt and solder or use ring crimps? EDIT: Also random question, but if you know anything about Optima Batteries, do you know if there is a big difference between the group D34 and the D35? I was forced to pay 20$ extra today because the D34 wouldn't fit under my hood because my stock battery had reverse posts. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Building dual ported box for two 12 inch Type R's - What tools do I need?
Top
Menu
Home
Refresh