Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Subwoofers
Build around Alpine X 12"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="fithwheel" data-source="post: 8646065" data-attributes="member: 674179"><p>you seem a little confused. Your sub is rated to handle 900 watts RMS total. You only have 1 alpine x 12 right? You're going to want to wire it parallel so it'll be at a 2 ohm load. You should get on you tube and check out amp dynos. Search Big d wiz and budget gem or budget bust and watch their videos. Most of their videos speak on the efficiency of the amplifier they are testing. If you already have a rf prime 1200 I'd just use that. It's fairly efficient. Definitely could do a lot worse then what you already have as far as efficiency. You got a birth sheet with that prime right. Whats it do at 2ohms? Probably over 800 watts i would imagine.</p></blockquote><p></p>
[QUOTE="fithwheel, post: 8646065, member: 674179"] you seem a little confused. Your sub is rated to handle 900 watts RMS total. You only have 1 alpine x 12 right? You're going to want to wire it parallel so it'll be at a 2 ohm load. You should get on you tube and check out amp dynos. Search Big d wiz and budget gem or budget bust and watch their videos. Most of their videos speak on the efficiency of the amplifier they are testing. If you already have a rf prime 1200 I'd just use that. It's fairly efficient. Definitely could do a lot worse then what you already have as far as efficiency. You got a birth sheet with that prime right. Whats it do at 2ohms? Probably over 800 watts i would imagine. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Subwoofers
Build around Alpine X 12"
Top
Menu
Home
Refresh