Reply to thread

Message: <blockquote data-quote="NIHL8ION" data-source="post: 8098527" data-attributes="member: 653120"><p>This should work, but if it still won't fit just trim the wire down a little bit - ie: Cut off end &amp; start fresh, then strip back desired length, then pull down / fold the outer most layer(s) of wire leaving the desired gauge / thickness standing straight up still in the center of where you folded down wire... Cut off the wire you folded down &amp; you will be good. Either way always just use both sides of the push terminal as this will allow you to fit the biggest gauge of wire you can fit because you won't be doubling it up into one hole opening //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif</p></blockquote><p></p>

Top