Reply to thread

Message

<blockquote data-quote="saltyreefguy" data-source="post: 2069049" data-attributes="member: 564722"><p>i have 2 jl 12w6v2-d4, both wired for 4ohm, and its hookup to a ppi art series 1200.2 amp, where if its 4ohm, it will output 1200watts bridged mono, its sounds somewhat okay, the box plans were per jl specs,&nbsp; for one sub, so i just double the length to have 2 subs, its a sealed box, with center divider, but when i push the sub down to see if the seal is holding, only a little but, not a tight seal where the sub slowing sucks air to get back into its normal position, i am using a clarion vrx935vd dvd touch hu unit, then to a audio control eipicenter, then a audiocontrol eqs, i do have and tried ppi equipment like eq, and crossover frx456, that sounded pretty&nbsp; good when it was setup for a mtx 9500 sub dvc, and mtx 10d, but i think that and had to much thd distortion, but that even sound alot better, so i figured i upgrade on the bass part, i totally think it needs tweaking, but is the box, the accessories(eq,xover, etc..). so anyone got any suggestions, like maybe i should go ported instead? or change to other equipment, got lots of audiocontrol stuff, mayb i should got with sep. units, thanks, for any helpful input.</p></blockquote><p></p>

[QUOTE="saltyreefguy, post: 2069049, member: 564722"] i have 2 jl 12w6v2-d4, both wired for 4ohm, and its hookup to a ppi art series 1200.2 amp, where if its 4ohm, it will output 1200watts bridged mono, its sounds somewhat okay, the box plans were per jl specs, for one sub, so i just double the length to have 2 subs, its a sealed box, with center divider, but when i push the sub down to see if the seal is holding, only a little but, not a tight seal where the sub slowing sucks air to get back into its normal position, i am using a clarion vrx935vd dvd touch hu unit, then to a audio control eipicenter, then a audiocontrol eqs, i do have and tried ppi equipment like eq, and crossover frx456, that sounded pretty good when it was setup for a mtx 9500 sub dvc, and mtx 10d, but i think that and had to much thd distortion, but that even sound alot better, so i figured i upgrade on the bass part, i totally think it needs tweaking, but is the box, the accessories(eq,xover, etc..). so anyone got any suggestions, like maybe i should go ported instead? or change to other equipment, got lots of audiocontrol stuff, mayb i should got with sep. units, thanks, for any helpful input. [/QUOTE]

Verification