Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Box for two Sundown SA 15's
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="tigermax14" data-source="post: 7556237" data-attributes="member: 584480"><p>Here are the current plans for my box.</p><p></p><p>The box will be for two SA 15's powered by an SAX 1200 in an 05 tahoe. Dimensions will be 44"x22"x18" which comes out to 8.3^2 feet before displacement. Subs up, single 8 inch sonotube aeroport to the rear tuned at 31hz. Box comes to about 7.4^2 after sub, port, and dowel bracing displacement. I know the box is a little on the large side but this was recommended by Jacob at sundown to maximize the power I'm running, and the port area is a little low but this is a daily/lows box. Any input is appreciated and also what is the best way to run my speaker wires from the amp into the box? Also will take any tips on flaring sonotube. If I left anything out just ask. Thanks in advance</p></blockquote><p></p>
[QUOTE="tigermax14, post: 7556237, member: 584480"] Here are the current plans for my box. The box will be for two SA 15's powered by an SAX 1200 in an 05 tahoe. Dimensions will be 44"x22"x18" which comes out to 8.3^2 feet before displacement. Subs up, single 8 inch sonotube aeroport to the rear tuned at 31hz. Box comes to about 7.4^2 after sub, port, and dowel bracing displacement. I know the box is a little on the large side but this was recommended by Jacob at sundown to maximize the power I'm running, and the port area is a little low but this is a daily/lows box. Any input is appreciated and also what is the best way to run my speaker wires from the amp into the box? Also will take any tips on flaring sonotube. If I left anything out just ask. Thanks in advance [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Box for two Sundown SA 15's
Top
Menu
Home
Refresh