Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
blown Type R
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="EvilEd" data-source="post: 8442799" data-attributes="member: 636290"><p>I have a Fosgate Punch 1000BD that's been pushing two JL 12w6v3 at 1ohm for about 8 years without issue, I hooked the amp up to 1 alpine type R dual 2 ohm wired to 1 ohm in a 1.6 sq ft ported to 39 hz box with the infrasonic filter turned on on the amp but the sub blew after about 20 minutes of moderately loud usage (70-80%). I know the specs on the box weren't perfect and the infrasonic filter at 29 hz is far from 39 hz, but should it really have been enough to blow the sub? The gain was set really low, lower than it was with the W6s. I didn't hear distortion and by the time i smelled the smoke it was too late. I'm wondering if I got a bad sub (purchased from one of these cheap no warranty stores) or if the box could have caused the damage.</p></blockquote><p></p>
[QUOTE="EvilEd, post: 8442799, member: 636290"] I have a Fosgate Punch 1000BD that's been pushing two JL 12w6v3 at 1ohm for about 8 years without issue, I hooked the amp up to 1 alpine type R dual 2 ohm wired to 1 ohm in a 1.6 sq ft ported to 39 hz box with the infrasonic filter turned on on the amp but the sub blew after about 20 minutes of moderately loud usage (70-80%). I know the specs on the box weren't perfect and the infrasonic filter at 29 hz is far from 39 hz, but should it really have been enough to blow the sub? The gain was set really low, lower than it was with the W6s. I didn't hear distortion and by the time i smelled the smoke it was too late. I'm wondering if I got a bad sub (purchased from one of these cheap no warranty stores) or if the box could have caused the damage. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
blown Type R
Top
Menu
What's new
Forum list