Reply to thread

Message

<blockquote data-quote="GreenGA98" data-source="post: 1918596" data-attributes="member: 569101">Hi everyone, i&#039;m new to this site and just have a quick questionI have 2 Kicker CompVRs, 4ohm DVC, 400w rms each, 800w max eachSize: 12 inchRec. Sealed Box Dims: 1 - 4.6 cu.ft.Rec. Ported Box Dims: 1.75 - 2.25 cu.ftFree Air Usage: not recommendedSensitivity: 86.7 dBFrequency Response: 25-500 HzRecommended RMS Power: 400WPeak Power Handling: 800WImpedance: dual 4 ohms subwoofer wiring optionsand an amp Power Acoustik LT9802-Channel Amp SpecificationsAmplifier Type: 2-channelRMS Power @ 4 Ohms: 220W x 2THD at 4-Ohm RMS Power: 0.02 %Bridged RMS Power @ 4 Ohms: 560W x 1Speaker Level Inputs: noPreamp Outputs: yesBuilt-In Crossovers: HP/LPBass Boost: 0 - 24 dBFrequency Response: 10-30,000 HzSignal to Noise Ratio: 98 dBFuse Rating: n/aWHat would be the best way to wire my subs, right now they are wired parallel with the amp NOT bridged. Can I bridge my 2 channel amp for more power, just wondering?</blockquote>

[QUOTE="GreenGA98, post: 1918596, member: 569101"] Hi everyone, i'm new to this site and just have a quick question I have 2 Kicker CompVRs, 4ohm DVC, 400w rms each, 800w max each Size: 12 inch Rec. Sealed Box Dims: 1 - 4.6 cu.ft. Rec. Ported Box Dims: 1.75 - 2.25 cu.ft Free Air Usage: not recommended Sensitivity: 86.7 dB Frequency Response: 25-500 Hz Recommended RMS Power: 400W Peak Power Handling: 800W Impedance: dual 4 ohms subwoofer wiring options and an amp Power Acoustik LT980 2-Channel Amp SpecificationsAmplifier Type: 2-channel RMS Power @ 4 Ohms: 220W x 2 THD at 4-Ohm RMS Power: 0.02 % Bridged RMS Power @ 4 Ohms: 560W x 1 Speaker Level Inputs: no Preamp Outputs: yes Built-In Crossovers: HP/LP Bass Boost: 0 - 24 dB Frequency Response: 10-30,000 Hz Signal to Noise Ratio: 98 dB Fuse Rating: n/a WHat would be the best way to wire my subs, right now they are wired parallel with the amp NOT bridged. Can I bridge my 2 channel amp for more power, just wondering? [/QUOTE]

Verification