Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Bass cuts out and makes popping noise once my volume goes past 25/30
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="likoewoe" data-source="post: 8832390" data-attributes="member: 688350"><p>I have a 2014 Hyundai Santa Fe sport stock alt, a kisloc2 for stock radio support running all ofc wire into a Jensen 600w amp at about 240x1</p><p>@ 4 ohms. With that running into a dual 4ohm 150w each rms kicker c12’s. All wire is ofc, and is the appropriate gauge with power wires that fit the terminals perfectly. Everything is going good until either the bass hits super hard, or I turn it up past 25 or 30 out of 45. The bass begins to cut out and make a popping noise. The amp isn’t going into protect either. I’ve reinforced my grounds, and upgraded all wire. Idk what the issue could be at this point.</p></blockquote><p></p>
[QUOTE="likoewoe, post: 8832390, member: 688350"] I have a 2014 Hyundai Santa Fe sport stock alt, a kisloc2 for stock radio support running all ofc wire into a Jensen 600w amp at about 240x1 @ 4 ohms. With that running into a dual 4ohm 150w each rms kicker c12’s. All wire is ofc, and is the appropriate gauge with power wires that fit the terminals perfectly. Everything is going good until either the bass hits super hard, or I turn it up past 25 or 30 out of 45. The bass begins to cut out and make a popping noise. The amp isn’t going into protect either. I’ve reinforced my grounds, and upgraded all wire. Idk what the issue could be at this point. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Bass cuts out and makes popping noise once my volume goes past 25/30
Top
Menu
Home
Refresh