Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Bandpass Crossover or DSP?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ThxOne" data-source="post: 8696104" data-attributes="member: 675210"><p>As Jeffdachef said... you need an amp. I also have the DMX706S short chassis, media only head unit. You can get away with a single amp... a nice 5 channel amp. If it were me and it was my ride I would run two tweeters, two midrange drivers and a single subwoofer off a 5 channel amp with the eXcelon in active mode. This means only one power and ground wire to power the amp saves install hassle and saves room... ish. Less wiring, less noise. Spend the saved money on sound deadening material. A simple one amp, active set up that should be very loud and very clean sounding. What vehicle is it?</p></blockquote><p></p>
[QUOTE="ThxOne, post: 8696104, member: 675210"] As Jeffdachef said... you need an amp. I also have the DMX706S short chassis, media only head unit. You can get away with a single amp... a nice 5 channel amp. If it were me and it was my ride I would run two tweeters, two midrange drivers and a single subwoofer off a 5 channel amp with the eXcelon in active mode. This means only one power and ground wire to power the amp saves install hassle and saves room... ish. Less wiring, less noise. Spend the saved money on sound deadening material. A simple one amp, active set up that should be very loud and very clean sounding. What vehicle is it? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Bandpass Crossover or DSP?
Top
Menu
Home
Refresh