Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Audiopipe APCLE 10001D going into protect.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="gonzalgi21" data-source="post: 8642585" data-attributes="member: 605298"><p>Bought a brand new apcle 10001D for my alpine sbr8 inch small sub which ended up blowing the sub, didnt mind that since i had plans on buying a newer sub down the road. New sub is Sundown SA-8, sub hits SO much harder than the alpine which was expected. Problem is from the day i installed the sub my amp goes into protect after approximately 20-30 min of having the volume relatively high. Wired at 1ohm, with alpine sub never had this issue with the amp. Part of the reason i bought the amp is because of its 1 ohm stable capability. My lights are also dimming a lot with this new sub. Do i need a second battery? Any suggestions? (Have triple checked wiring already and gain is set at about 50%).</p></blockquote><p></p>
[QUOTE="gonzalgi21, post: 8642585, member: 605298"] Bought a brand new apcle 10001D for my alpine sbr8 inch small sub which ended up blowing the sub, didnt mind that since i had plans on buying a newer sub down the road. New sub is Sundown SA-8, sub hits SO much harder than the alpine which was expected. Problem is from the day i installed the sub my amp goes into protect after approximately 20-30 min of having the volume relatively high. Wired at 1ohm, with alpine sub never had this issue with the amp. Part of the reason i bought the amp is because of its 1 ohm stable capability. My lights are also dimming a lot with this new sub. Do i need a second battery? Any suggestions? (Have triple checked wiring already and gain is set at about 50%). [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Audiopipe APCLE 10001D going into protect.
Top
Menu
Home
Refresh