Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
AQ causing problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Crzy" data-source="post: 5758673" data-attributes="member: 567648"><p>not what you would think though, how would i go about reinforing the mounts on my headunit to cause it not to skip when the bass hits? when i put pressure on the faceplate with my hand it will stop the skipping but the second i remove my hand the skipping will start again.</p><p></p><p>made a video so you can hear and see, voltage is aright dips to 12.6- 12.4 on hard bass with rpm at 1.5k-2k. only electrical i have done is a yellowtop in back. gains still arent fully adjusted yet and my camera picked up no flex for you guys. stole the electrical tape idea from someone here was a good idea, but camera still couldnt pick anything up //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif</p><p></p><p>[MEDIA=youtube]oaSTYWhDGGE[/MEDIA]</p></blockquote><p></p>
[QUOTE="Crzy, post: 5758673, member: 567648"] not what you would think though, how would i go about reinforing the mounts on my headunit to cause it not to skip when the bass hits? when i put pressure on the faceplate with my hand it will stop the skipping but the second i remove my hand the skipping will start again. made a video so you can hear and see, voltage is aright dips to 12.6- 12.4 on hard bass with rpm at 1.5k-2k. only electrical i have done is a yellowtop in back. gains still arent fully adjusted yet and my camera picked up no flex for you guys. stole the electrical tape idea from someone here was a good idea, but camera still couldnt pick anything up [IMG]//content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif[/IMG] [MEDIA=youtube]oaSTYWhDGGE[/MEDIA] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
AQ causing problems
Top
Menu
What's new
Forum list
