Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Amplifier Help...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="PhatTonyDeMarco" data-source="post: 970288" data-attributes="member: 560787"><p>Well I just installed my new HX2's, with a JBL BP600.1 amp. The wiring was already ran through out the car, because I had an Audiobahn A8002T amp before this and had no problems. With that in mind, my amp will not turn off with my head unit, and even stays on when my car is off. The remote is wired correctly, do not suggest that please. I checked my HU manual and soldered the correct wire, and it worked fine with the amp prior to this. But my head unit has an anti theft light that stays on after the face is removed, could this small amount of power be keeping my amp on? Any ideas?.. Could I install a switch to the remot of the amp?</p></blockquote><p></p>
[QUOTE="PhatTonyDeMarco, post: 970288, member: 560787"] Well I just installed my new HX2's, with a JBL BP600.1 amp. The wiring was already ran through out the car, because I had an Audiobahn A8002T amp before this and had no problems. With that in mind, my amp will not turn off with my head unit, and even stays on when my car is off. The remote is wired correctly, do not suggest that please. I checked my HU manual and soldered the correct wire, and it worked fine with the amp prior to this. But my head unit has an anti theft light that stays on after the face is removed, could this small amount of power be keeping my amp on? Any ideas?.. Could I install a switch to the remot of the amp? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Amplifier Help...
Top
Menu
What's new
Forum list
