Reply to thread

Message

<blockquote data-quote="Darion" data-source="post: 1237196" data-attributes="member: 563897">As stated above I have a question about amp output.&nbsp; I am going to run my system with a Mmats SQ 4150 the specs are as follows;SPECIFICATIONSSQ41504 x 150Wrms @&nbsp; 4 ohm2 X 300Wrms @ 4 ohm monoFrequency Response (-3db) 10Hz to 50KHzSignal to Noise Ratio -105db A weightedDistortion @ Rated OutputDamping Factor @ 100 Hz &amp;gt;125Input Sensitivity 150mV to 2.5VrmsIdle Current 1 ampI will be running a set of CDT three way comps in the doors with two channels and a single 10&quot; sub, brand and make not decided, with the other two.Soooo, what would you think the sub channels will put out at two ohms mono?Also, recommendations on a good SQ sub to fit the output wattage would be sweet!Thanks for the info,Darion</blockquote>

[QUOTE="Darion, post: 1237196, member: 563897"] As stated above I have a question about amp output. I am going to run my system with a Mmats SQ 4150 the specs are as follows; SPECIFICATIONS SQ4150 4 x 150Wrms @ 4 ohm 2 X 300Wrms @ 4 ohm mono Frequency Response (-3db) 10Hz to 50KHz Signal to Noise Ratio -105db A weighted Distortion @ Rated Output Damping Factor @ 100 Hz >125 Input Sensitivity 150mV to 2.5Vrms Idle Current 1 amp I will be running a set of CDT three way comps in the doors with two channels and a single 10" sub, brand and make not decided, with the other two. Soooo, what would you think the sub channels will put out at two ohms mono? Also, recommendations on a good SQ sub to fit the output wattage would be sweet! Thanks for the info, Darion [/QUOTE]

Verification