Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Amp not outputting correct voltage?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="09VIC" data-source="post: 8570700" data-attributes="member: 673062"><p>Ok and next question if I were to get another amp the audiopipe 1800 seems like a good way to go and until then to save my subs would it be possible to run them at 2 ohms off of my two different amplifiers if they are gain matched? The other amp is a belva bb2000 and whole no true numbers exist the bb3000 when dynod did about 1400 rms so the bb2000 probably makes 1000 and 500 at 2 ohm. My subs are in a ported box with seperate Chambers but they share the port.</p></blockquote><p></p>
[QUOTE="09VIC, post: 8570700, member: 673062"] Ok and next question if I were to get another amp the audiopipe 1800 seems like a good way to go and until then to save my subs would it be possible to run them at 2 ohms off of my two different amplifiers if they are gain matched? The other amp is a belva bb2000 and whole no true numbers exist the bb3000 when dynod did about 1400 rms so the bb2000 probably makes 1000 and 500 at 2 ohm. My subs are in a ported box with seperate Chambers but they share the port. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Amp not outputting correct voltage?
Top
Menu
What's new
Forum list