Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp Not Accepting Power
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ctmaudi" data-source="post: 7041657" data-attributes="member: 626567"><p>Finally got to hook up my new subs and what not today, and the amp wont take power. I tested volts all the way down to power cable, and it was steady the whole way. Once the cable is plugged in the amp, it stops reading any voltage at all. The ground and remote wires are fine, even tried the remote to the power. RCAs are tight, subs werent plugged in.</p><p></p><p>Its a Planet Audio P2250D. The fuse is a 300 amp Kicker, and using all 1/0awg kicker wire. Fuze is in tight, and there is 14v+ before and after it.</p><p></p><p>Any ideas? Maybe the terminal on the amp came loose on the inside?</p></blockquote><p></p>
[QUOTE="ctmaudi, post: 7041657, member: 626567"] Finally got to hook up my new subs and what not today, and the amp wont take power. I tested volts all the way down to power cable, and it was steady the whole way. Once the cable is plugged in the amp, it stops reading any voltage at all. The ground and remote wires are fine, even tried the remote to the power. RCAs are tight, subs werent plugged in. Its a Planet Audio P2250D. The fuse is a 300 amp Kicker, and using all 1/0awg kicker wire. Fuze is in tight, and there is 14v+ before and after it. Any ideas? Maybe the terminal on the amp came loose on the inside? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp Not Accepting Power
Top
Menu
What's new
Forum list
