Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp,LOC and sub Causing factory alarm issue
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Mrlopez512" data-source="post: 8682659" data-attributes="member: 677863"><p>I have a 2007 chevy suburban with bose system. I ran 4 gauge amp wire kit and installed LC2i. I tapped into the bose sub wires to get the signal to the LOC. the amp powers 2 entry level 10's... nothing major at all. During installation I did remove positive battery terminal. About 15 minutes after installation and testing the factory alarm goes off. Then 20 minutes later the same. Over the next 2 weeks this factory alarm is going nuts at least twice a day. Then I notice after I close my door the radio will turn back on and the whole dash will be flickering like crazy... then the factory alarm again. I started sleeping with my keys in my hand to kill the alarm because I knew it was gonna go off. After a couple of nights of terrible sleep I started disconnecting the battery at night. </p><p>I finally gave up and decided to remove the power wire and disconnect the signal to the LOC. It's been 2 weeks and the alarm hasnt gone off since. </p><p>I would like to have my subs back. The only 2 point of the electrical system I touched were the battery and signal wires to the sub. Help!</p></blockquote><p></p>
[QUOTE="Mrlopez512, post: 8682659, member: 677863"] I have a 2007 chevy suburban with bose system. I ran 4 gauge amp wire kit and installed LC2i. I tapped into the bose sub wires to get the signal to the LOC. the amp powers 2 entry level 10's... nothing major at all. During installation I did remove positive battery terminal. About 15 minutes after installation and testing the factory alarm goes off. Then 20 minutes later the same. Over the next 2 weeks this factory alarm is going nuts at least twice a day. Then I notice after I close my door the radio will turn back on and the whole dash will be flickering like crazy... then the factory alarm again. I started sleeping with my keys in my hand to kill the alarm because I knew it was gonna go off. After a couple of nights of terrible sleep I started disconnecting the battery at night. I finally gave up and decided to remove the power wire and disconnect the signal to the LOC. It's been 2 weeks and the alarm hasnt gone off since. I would like to have my subs back. The only 2 point of the electrical system I touched were the battery and signal wires to the sub. Help! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp,LOC and sub Causing factory alarm issue
Top
Menu
Home
Refresh