Reply to thread

Message

<blockquote data-quote="Volvowith18psi" data-source="post: 6832771" data-attributes="member: 621805">So, I was on the way to work this morning, with a medium bump going on, no where near what the system usually bumps at, anyway, my amp just shut off.The system had been on for a whole 15m, no way it over-heated, was cold to the touch when I pulled over 5min later.System is Kenwood HU, model unknown, &#039;10 model tho, Kenweed 9105D @ 1ohm and 1x Kicker 12L5I checked everything I could before comming into work, Main power cable fuse wasnt broken, everything on the back of the HU looked normal, all connections into the amp were solid, ground connection, doesn&#039;t move.... Amp-&amp;gt;Box-&amp;gt;Speaker connections are all solid. Fuses on the amp are all intact....Any ideas? did my amp blow? Mind you all this is newEdit to add: volts@ the amp are 7.65+- car at idle.... battery / alt @ 14ish+- as usuall, still no juice, think its a signal wire issue...</blockquote>

[QUOTE="Volvowith18psi, post: 6832771, member: 621805"] So, I was on the way to work this morning, with a medium bump going on, no where near what the system usually bumps at, anyway, my amp just shut off. The system had been on for a whole 15m, no way it over-heated, was cold to the touch when I pulled over 5min later. System is Kenwood HU, model unknown, '10 model tho, Kenweed 9105D @ 1ohm and 1x Kicker 12L5 I checked everything I could before comming into work, Main power cable fuse wasnt broken, everything on the back of the HU looked normal, all connections into the amp were solid, ground connection, doesn't move.... Amp->Box->Speaker connections are all solid. Fuses on the amp are all intact.... Any ideas? did my amp blow? Mind you all this is new Edit to add: volts@ the amp are 7.65+- car at idle.... battery / alt @ 14ish+- as usuall, still no juice, think its a signal wire issue... [/QUOTE]

Verification