Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp installation questons
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="blackbonnie" data-source="post: 2849984" data-attributes="member: 573596"><p>are you running two amps or one? if you are just gonna run one, i would personally run all new wire, so you dont have added resistance by splicing it, and hard for the current to reach your amp. if you are running two, then just use a distribution block, where the wire ends then add on from there. the reason i asked how many you were running was because it sounded like you were running two in your original post. and also if you are thinking about ever adding on, then you may want to just add a distribution block right now, and then you wouldnt have to run new wire, and it would be easier to add on later down the road.</p></blockquote><p></p>
[QUOTE="blackbonnie, post: 2849984, member: 573596"] are you running two amps or one? if you are just gonna run one, i would personally run all new wire, so you dont have added resistance by splicing it, and hard for the current to reach your amp. if you are running two, then just use a distribution block, where the wire ends then add on from there. the reason i asked how many you were running was because it sounded like you were running two in your original post. and also if you are thinking about ever adding on, then you may want to just add a distribution block right now, and then you wouldnt have to run new wire, and it would be easier to add on later down the road. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp installation questons
Top
Menu
Home
Refresh