Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Amp goes into protect mode- burning smell and spark at speaker wire!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jdwarre" data-source="post: 8285531" data-attributes="member: 661940"><p>hey everyone!</p><p></p><p>So I am having a problem with my amp.</p><p></p><p>My current setup has been working great for the past 2 years, zero problems until last week..</p><p></p><p>I was going along and then boom my sub cut out and I realized my amp had gone into "protect mode".</p><p></p><p>I turned off my car and then turned it back on and everything was fine until I turned my volume up and them boom.. again.. sub cut off and the amp went into protect mode!</p><p></p><p>I unhooked everything from the amp, re-connected it all, tested it out and whenever I play my stereo at loud volume, there is a spark on my positive speaker wire where the amp is then it goes into protect mode and I can smell plastic burning..</p><p></p><p>Any suggestions on how to fix this please?</p><p></p><p>Thank you very much in advance!!</p></blockquote><p></p>
[QUOTE="jdwarre, post: 8285531, member: 661940"] hey everyone! So I am having a problem with my amp. My current setup has been working great for the past 2 years, zero problems until last week.. I was going along and then boom my sub cut out and I realized my amp had gone into "protect mode". I turned off my car and then turned it back on and everything was fine until I turned my volume up and them boom.. again.. sub cut off and the amp went into protect mode! I unhooked everything from the amp, re-connected it all, tested it out and whenever I play my stereo at loud volume, there is a spark on my positive speaker wire where the amp is then it goes into protect mode and I can smell plastic burning.. Any suggestions on how to fix this please? Thank you very much in advance!! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Amp goes into protect mode- burning smell and spark at speaker wire!
Top
Menu
Home
Refresh