Reply to thread

Message

<blockquote data-quote="boosted4" data-source="post: 6677431" data-attributes="member: 619452">im pretty much set on the BA pro60se for my front stage, about $330 from woofersetc. im looking at the sundown sax 125.2 for it. i have 2 basic questions.1. is this amp good enough for the components? from the site if you didnt know the specs.Rated power output----RMS power, 4 ohm stereo125W x 2CH----RMS power, 2 ohm stereo200W x 2CH----RMS power, 4 ohm bridged400W x 1CHSignal to Noise Ratio &amp;gt;90dBLow pass frequency crossover 50Hz ~ 5KHzHigh Pass Crossover 30Hz ~ 3KHzVariable Subsonic Filter 10Hz to 500HzBass Boost 0~18dBVariable Bass-Boost Frequency Control 35Hz to 120HzFrequency Response 10Hz ~ 40KHz (+/-1dB)THD@RMS WattsChannel Separation 75dBFuse Rating 20A x 3Input Sensitivity Variable 200mV~6V (+/- 5%)Dimensions 252(W) x 58(H) x 340(L)mm2. when i hook the amp up, should it be tweeters on 1 channel and drivers on the other? or 1 side 1 channel? idk if it makes a diff. either waythanks in advance for help... extra thanks for the most helpful response //content.invisioncic.com/y282845/emoticons/veryhappy.gif.fec4fed33b4a1279cf10bdd45a039dae.gif</blockquote>

[QUOTE="boosted4, post: 6677431, member: 619452"] im pretty much set on the BA pro60se for my front stage, about $330 from woofersetc. im looking at the sundown sax 125.2 for it. i have 2 basic questions. 1. is this amp good enough for the components? from the site if you didnt know the specs. Rated power output ----RMS power, 4 ohm stereo 125W x 2CH ----RMS power, 2 ohm stereo 200W x 2CH ----RMS power, 4 ohm bridged 400W x 1CH Signal to Noise Ratio >90dB Low pass frequency crossover 50Hz ~ 5KHz High Pass Crossover 30Hz ~ 3KHz Variable Subsonic Filter 10Hz to 500Hz Bass Boost 0~18dB Variable Bass-Boost Frequency Control 35Hz to 120Hz Frequency Response 10Hz ~ 40KHz (+/-1dB) THD@RMS Watts Channel Separation 75dB Fuse Rating 20A x 3 Input Sensitivity Variable 200mV~6V (+/- 5%) Dimensions 252(W) x 58(H) x 340(L)mm 2. when i hook the amp up, should it be tweeters on 1 channel and drivers on the other? or 1 side 1 channel? idk if it makes a diff. either way thanks in advance for help... extra thanks for the most helpful response [IMG]//content.invisioncic.com/y282845/emoticons/veryhappy.gif.fec4fed33b4a1279cf10bdd45a039dae.gif[/IMG] [/QUOTE]

Verification