Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp cutting out on bass hits, but amp not in protection mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="AnthonyO" data-source="post: 8258219" data-attributes="member: 563887"><p>The Power Acoustik was not requiring the amperage the JL is. So as it pulls amps its not getting the adequate ground. I had a friend with a Soundstream Amp I installed and scratched my head for an hour trying to figure out what I did wrong. It would power on, play at low volumes, turn up the volume and it would shut down. I redid the ground and was golden. Its the easiest to check and replace, so start there.</p></blockquote><p></p>
[QUOTE="AnthonyO, post: 8258219, member: 563887"] The Power Acoustik was not requiring the amperage the JL is. So as it pulls amps its not getting the adequate ground. I had a friend with a Soundstream Amp I installed and scratched my head for an hour trying to figure out what I did wrong. It would power on, play at low volumes, turn up the volume and it would shut down. I redid the ground and was golden. Its the easiest to check and replace, so start there. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Amp cutting out on bass hits, but amp not in protection mode
Top
Menu
Home
Refresh