Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
amp and sub compatiability
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="d4vew557" data-source="post: 6771867" data-attributes="member: 619985"><p>ok. this is my problem.</p><p></p><p>i have a mrv t420 which is i have bridged i was planning on using it to run a 10" alpine type r but i'm not sure it will be powerful enough. i had planned on purchasing a dual 2ohm voice coil unit and wiring it so the amp see's a 4ohm load.</p><p></p><p>I think i may need to upgrade the amp in the future to a mono block but if i do i would be looking to run it at 2ohms but the the sub i was going to get won't be any good then as i would need a dual 4ohm unit.</p><p></p><p>is it possible to run only one voice coil that way i could get a 4ohm sub and use one coil for now then when i upgrade the amp i could rewire it for a 2ohm load.</p></blockquote><p></p>
[QUOTE="d4vew557, post: 6771867, member: 619985"] ok. this is my problem. i have a mrv t420 which is i have bridged i was planning on using it to run a 10" alpine type r but i'm not sure it will be powerful enough. i had planned on purchasing a dual 2ohm voice coil unit and wiring it so the amp see's a 4ohm load. I think i may need to upgrade the amp in the future to a mono block but if i do i would be looking to run it at 2ohms but the the sub i was going to get won't be any good then as i would need a dual 4ohm unit. is it possible to run only one voice coil that way i could get a 4ohm sub and use one coil for now then when i upgrade the amp i could rewire it for a 2ohm load. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
amp and sub compatiability
Top
Menu
What's new
Forum list
