Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Amp @ 4ohms for an Eclipse 8200?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="99StangGt" data-source="post: 2065088" data-attributes="member: 560116"><p>Here are the specs</p><p></p><p>800 watts RMS x 1 in bridged mode</p><p></p><p>400 watts RMS x 2 at 2 ohms</p><p></p><p>200 watts RMS x 2 at 4 ohms</p><p></p><p>variable front and rear high- and low-pass filters (50-5000 Hz at 12dB/octave)</p><p></p><p>CEA-2006 compliant</p><p></p><p>multiplier x10 switch converts filters to variable from 500 to 5,000 Hz</p><p></p><p>LED clipping indicators</p><p></p><p>preamp-level inputs and outputs</p><p></p><p>front end defeat bypasses gain and crossover controls</p><p></p><p>fuse rating: 30A x 3</p><p></p><p>4-gauge power and ground leads</p><p></p><p>11-7/16"W x 2-3/8"H x 17"D</p><p></p><p>bridging 2 channel amps almost always will only bridge at 4 ohms, there are a lot of exceptions.</p></blockquote><p></p>
[QUOTE="99StangGt, post: 2065088, member: 560116"] Here are the specs 800 watts RMS x 1 in bridged mode 400 watts RMS x 2 at 2 ohms 200 watts RMS x 2 at 4 ohms variable front and rear high- and low-pass filters (50-5000 Hz at 12dB/octave) CEA-2006 compliant multiplier x10 switch converts filters to variable from 500 to 5,000 Hz LED clipping indicators preamp-level inputs and outputs front end defeat bypasses gain and crossover controls fuse rating: 30A x 3 4-gauge power and ground leads 11-7/16"W x 2-3/8"H x 17"D bridging 2 channel amps almost always will only bridge at 4 ohms, there are a lot of exceptions. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Amp @ 4ohms for an Eclipse 8200?
Top
Menu
What's new
Forum list
