Reply to thread

Message

<blockquote data-quote="okiedokie" data-source="post: 6708165" data-attributes="member: 599205">Hey av8teryes I have the dsc480.The 480 &amp;amp; 4125 difference is wattage.For the 41251) 500x2 bridged will give you 500 per side in Mono channel2) if you bridge the amp into 2 channels you need to putamp in 2 channel mode( 2 or 4 channel).3) if you want stereo into 2 channels you need to use a Y-adapter.4) if you use the amp in a 3 channel mode you still need a y-adapter.You can use channels 1-2 for the front &amp;amp; 3-4 plus the mono out putsas the sub out puts into 4 ohms.The reason I asked who made these amps was because I called maxxsonics asking for spec,which there tech support didn&#039;t have much info on this.I needed to know what is the rated power @ 12 volts which they don&#039;t know,&amp;amp; they don&#039;t give these specs in there manual, website or any place.I did ask them one other question, I asked them where was channel 1-2 on the amp.I was told channel 1 was on the left top &amp;amp; channel 2 was left bottom.They say all there amps where set up like that, not ture.Channel 1 is bottom left &amp;amp; channel 2 top left.I mean this doesn&#039;t mean anything, but I ask questions at times to see if thecompany that makes there products know there own gear.I think the dsc amps are built very solid, nice HP xover, nice warm sounding amp.Very very great buy of amp, I like this amp better then my pheonixgold amp.</blockquote>

[QUOTE="okiedokie, post: 6708165, member: 599205"] Hey av8ter yes I have the dsc480. The 480 & 4125 difference is wattage. For the 4125 1) 500x2 bridged will give you 500 per side in Mono channel 2) if you bridge the amp into 2 channels you need to put amp in 2 channel mode( 2 or 4 channel). 3) if you want stereo into 2 channels you need to use a Y-adapter. 4) if you use the amp in a 3 channel mode you still need a y-adapter. You can use channels 1-2 for the front & 3-4 plus the mono out puts as the sub out puts into 4 ohms. The reason I asked who made these amps was because I called maxxsonics asking for spec, which there tech support didn't have much info on this. I needed to know what is the rated power @ 12 volts which they don't know, & they don't give these specs in there manual, website or any place. I did ask them one other question, I asked them where was channel 1-2 on the amp. I was told channel 1 was on the left top & channel 2 was left bottom. They say all there amps where set up like that, not ture. Channel 1 is bottom left & channel 2 top left. I mean this doesn't mean anything, but I ask questions at times to see if the company that makes there products know there own gear. I think the dsc amps are built very solid, nice HP xover, nice warm sounding amp. Very very great buy of amp, I like this amp better then my pheonixgold amp. [/QUOTE]

Verification