Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Alpine IMPRINT MultEQ for CDA-9887 Problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="jgruberman" data-source="post: 6843259" data-attributes="member: 622410"><p>So I have the KTX-100EQ and spent the time tuning it. I had the mic set up on a tripod in my car, on each position that the software manager told me to place it. I performed the test on all 6 locations, and made sure there were no noises during the test.</p><p></p><p>I have front and rear speakers, no subs. All powered from a 4ch amp with all crossovers on the amp set to full.</p><p></p><p>When it was done, I saved the curve settings and turned it on. When I turned it on, it seemed dull and empty. There were no highs, and it the music sounded... "hollow". When I turned the MultEQ off, it sounded great(my own settings)... what was done wrong? Any ideas?</p></blockquote><p></p>
[QUOTE="jgruberman, post: 6843259, member: 622410"] So I have the KTX-100EQ and spent the time tuning it. I had the mic set up on a tripod in my car, on each position that the software manager told me to place it. I performed the test on all 6 locations, and made sure there were no noises during the test. I have front and rear speakers, no subs. All powered from a 4ch amp with all crossovers on the amp set to full. When it was done, I saved the curve settings and turned it on. When I turned it on, it seemed dull and empty. There were no highs, and it the music sounded... "hollow". When I turned the MultEQ off, it sounded great(my own settings)... what was done wrong? Any ideas? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Alpine IMPRINT MultEQ for CDA-9887 Problems
Top
Menu
What's new
Forum list
